How to Make a Reflex Deflex Longbow, Part 4: Gluing Up on the Form

Heads-up: This is an older build. The series ends with the bow in raw wood; the lacquer finish, final string, and shooting happened off camera.

What I do in this part

The prepared pieces go together on the reflex-deflex form. I scarify the glue surfaces, apply Unibond 800, and use an inner-tube wrap and clamps to hold the assembly while it cures.

Tools & materials

  • Prepared Ipe and hickory pieces.
  • Unibond 800 with slow hardener.
  • Reflex-deflex form.
  • Inner tube for wrapping.
  • Tip clamps.
  • Space heater for the curing setup shown.

Measurements

  • Tip clamps: 11 inches back from the tips.
  • Recorded curing temperature range: 70–85°F.

Step by step

  1. Scarify the mating surfaces before gluing.
  2. Apply the adhesive and assemble the pieces on the form.
  3. Wrap the assembly with the inner tube.
  4. Set the tip clamps in position.
  5. Leave the glue-up on the form to cure in the heated setup shown.

Tips

  • Watch the wrap and clamp placement in the video; they are part of holding the profile during the glue-up.
  • Glue mix: Unibond 800 slow, 16:1 by weight (80 g resin to 5 g hardener).
  • The heater setup is a record of this build, not a substitute for the adhesive’s curing instructions or safe heater clearances.

Up next: Part 5, unwrapping the bow and adding the riser.

← Part 3 | Watch the full series on YouTube | Part 5 →

Watch on YouTube

Leave a Comment

Your email address will not be published. Required fields are marked *