How to Make a Reflex Deflex Longbow, Part 5: Riser and First Tiller Pull

Heads-up: This is an older build. The series ends with the bow in raw wood; the lacquer finish, final string, and shooting happened off camera.

What I do in this part

The glue-up comes off the form. I unwrap it, clean up the squeeze-out, and add the sapele-and-Ipe riser. Then I rasp the fades and make the first tillering pull.

Tools & materials

  • The glued-up bow from part 4.
  • Sapele and Ipe for the riser.
  • Five-minute epoxy.
  • Rasp.
  • Tillering setup.

Step by step

  1. Unwrap the cured glue-up.
  2. Clean away the glue squeeze-out.
  3. Glue on the sapele-and-Ipe riser with five-minute epoxy.
  4. Rasp the fades to shape.
  5. Put the bow on the tillering setup for its first pull.

Tips

  • The backing glue-up and the riser use different adhesives in this build. Don’t confuse the five-minute epoxy here with the Unibond used on the form.
  • This is the first tillering pull, not the finished draw-weight result. The next part takes the bow further.

Up next: Part 6, horn tips and tillering.

← Part 4 | Watch the full series on YouTube | Part 6 →

Watch on YouTube

Leave a Comment

Your email address will not be published. Required fields are marked *