Heads-up: This is an older build. The series ends with the bow in raw wood; the lacquer finish, final string, and shooting happened off camera.
What I do in this part
The prepared pieces go together on the reflex-deflex form. I scarify the glue surfaces, apply Unibond 800, and use an inner-tube wrap and clamps to hold the assembly while it cures.
Tools & materials
- Prepared Ipe and hickory pieces.
- Unibond 800 with slow hardener.
- Reflex-deflex form.
- Inner tube for wrapping.
- Tip clamps.
- Space heater for the curing setup shown.
Measurements
- Tip clamps: 11 inches back from the tips.
- Recorded curing temperature range: 70–85°F.
Step by step
- Scarify the mating surfaces before gluing.
- Apply the adhesive and assemble the pieces on the form.
- Wrap the assembly with the inner tube.
- Set the tip clamps in position.
- Leave the glue-up on the form to cure in the heated setup shown.
Tips
- Watch the wrap and clamp placement in the video; they are part of holding the profile during the glue-up.
- Glue mix: Unibond 800 slow, 16:1 by weight (80 g resin to 5 g hardener).
- The heater setup is a record of this build, not a substitute for the adhesive’s curing instructions or safe heater clearances.
Up next: Part 5, unwrapping the bow and adding the riser.
