How to Make a Reflex Deflex Longbow, Part 2: The Ipe Belly

Heads-up: This is an older build. The series ends with the bow in raw wood; the lacquer finish, final string, and shooting happened off camera.

What I do in this part

This part is all about the belly of the bow, which is Ipe. I lay out the handle, fades, and limb tapers on the Ipe and cut it close to the lines. The hickory back comes next, in part 3.

Measurements

  • Handle layout: 11 inches. (Part 1 mentions 10 inches. I sometimes use 10, but this build went with 11. Handle length can be adjusted to suit you.)
  • Fades: 1 inch on each side of the handle, left untapered.
  • Width (top view): handle and fades left full, then the limbs taper from the end of the fades down to ⅝ inch.
  • Thickness (side view): handle and fades left alone, then the limbs taper from the end of the fades down to ⅜ inch.
  • Cutting allowance: leave ⅛ inch outside the lines. You can’t put back wood you’ve taken off, so work your way in slowly.

These are the layout measurements for this build, not a promise of finished draw weight. Tillering comes later.

Step by step

  1. Mark the handle area and fades.
  2. From the top view, lay out the width taper from the end of the fades down to ⅝ inch.
  3. From the side view, mark the thickness taper from the end of the fades down to ⅜ inch.
  4. Cut ⅛ inch outside the lines, then work your way in slowly.

Tips

  • Leave the cutting allowance. The line is a target for shaping, not a reason to take everything off in one pass.
  • Keep the width taper and thickness taper straight in your head. They are two different parts of the layout.

Up next: Part 3, making the Z-splice.

← Part 1 | Watch the full series on YouTube | Part 3 →

Watch on YouTube

Leave a Comment

Your email address will not be published. Required fields are marked *